To re-tune the S7070r at any time, select Satellite Scan. This will re-tune any Channels lost, if signal is sufficient, using frequencies already pre-configured with the S7070r.

If you require further information, the S7070r User Manual can be found online HERE.

'How to' re-tune the S7070r

Step 1: Open the Main Menu

  • With the Remote, go to Menu > Installation > Tuning Wizard.
  • Use the ◀ ▶ ▼ ▲ buttons on the Remote to navigate the Main Menu.
  • You'll be prompted to enter the PIN. The Default PIN is 0000.

Step 2: Select the Satellite

  • Select the Satellite you wish to scan, to confirm press the GREEN button on the Remote.
  • OPTUS D1 is the Satellite that broadcasts the Freeview Channels.

Step 3: Start the Scan

  • You'll be prompted to Network Search, by Default this is OFF. Press the OK button on the Remote.
  • Please wait for the scan to complete, the scan takes approx. 1-2 minutes.

NOTE: Press the YELLOW button to Add, or Edit a Satellite. Select LNB Setup to adjust the LNB Frequency, if required.